Tail Light - Husqvarna TE125 2011 Bedienungs- Und Wartungsanleitung

TAIL LIGHT

- Remove the two screws (1) on the inside of the rear
mudguard and then the lens (2).
- Push the bulb in (3), turn it counter clockwise and ex-
tract it from the bulb holder.
- Once the bulb has been replaced, reverse the above
procedure to reassemble.
NOTE: Be careful not to overtighten the screws.
1
2
EN - 38
REPLACING THE NUMBER PLATE BULB
3
- loosen screw (1) and remove the number plate bulb
- take bulb holder (3) and bulb (4) out of the support;
- pull the bulb (4) to detach it from bulb holder.
Once the bulb has been replaced, reverse the above pro-
cedure to reassemble.
(2) from the mudguard;
2
1
3
4