Husqvarna TE125 2011 Bedienungs- Und Wartungsanleitung Seite 70

ADJUSTMENT OF THE CLUTCH CONTROL LEVER
To adjust the clutch control lever, you will need to adjust
cable tension using the adjuster on the lever.
- Remove the rubber protection (1).
- Loosen the lock ring nut (3) and turn the tensioner
(2).
There should be at least 0.12 in. free play (A) before
the clutch begins to disengage.
- When through with the adjustment, tighten the lock
ring nut (3) and refit the rubber protection (1).
1
4
2
3
ADJUSTMENT OF THE STARTER LEVER
- Remove the rubber protection (1).
- Loosen the check nut (4) and turn the tensioner (4).
Free play (B) must be at least 0.12 in.
- When through with the adjustment, tighten the check
nut (5) and refit the rubber protection (1).
5
B
A
EN - 27