Environmental Protection; Symbol Identification - Ingersoll-Rand IQV20 Benutzerhandbuch

EN
● The BC1120 is a Class A product. In a residential, commercial or light industrial environment it may cause radio interference. This product
is not intended to be installed in a residential environment; in a commercial and light industrial environment with connection to the public mains
supply, the user may be required to take measures to reduce interference.
● This product is not intended to be used by travelers.
For additional information, refer to Battery Charger Safety Information Manual Form 10567832 and Battery Safety Information Manual
Form 10567840.
Manuals can be downloaded from ingersollrandproducts.com.
Product Specifications
Model Input
BC1120 100-240V AC ~ 50/60Hz,
BC1121 100W, 160-215VA
Instructions for Charging Battery
The charger shall be installed near a socket-outlet that is easily accessible.
Do not charge battery pack when temperature is below 32°F (0°C) or above 113°F (45°C). Completely charge new battery packs before using. Charg-
ing time is approximately 60-90 minutes.
Unplug charger and remove battery pack when not in use.
Action
Plug charger into 100-240V AC
power outlet.
Insert battery pack into charger.
Remove battery pack.
Legend: ä Flash l On m Off
Routine Maintenance
Unplug charger before cleaning. Plastic surfaces should only be cleaned with a slightly damp cloth. Keep vents free of dust and debris.
Charger should not be used with a damaged cord. Replacement cords and labels are available at nearest authorized Ingersoll Rand Service Center.
Refer all communications to nearest Ingersoll Rand Office or Distributor.

Environmental Protection

When life of Ingersoll Rand electrical product has expired, it must be recycled in accordance with all applicable standards and regulations (local,
state, country, federal, etc.). Improper disposal may endanger environment.

Symbol Identification

Return waste material for recycling.
Original instructions are in English. Other languages are a translation of the original instructions.
EN-4
Output
21V DC (BC1120),
12.6V/21V DC (BC1121), 4.0A
USB Type A, 5V DC, 500mA
D+/D- Connected, 200Ω
Condition
Power On (Stand-By).
Charging.
Fuel gauge will indicate state of charge.
Communications Failure.
Battery Identification / Read Fault
Reinsert battery. Battery may be defective.
Initial Temperature.
Charging paused until battery has returned to safe temperature.
Time Out.
Charge time exceeded. Battery may be defective.
In Cycle Temperature.
Charging paused until battery has returned to safe temperature.
Over Voltage.
High voltage detected. Battery may be defective.
Over Current.
High current detected. Battery may be defective.
Charge Completed.
Do not dispose of this product with
household waste material.
Battery
Model Number Voltage
BL2010 20V
BL2012 20V
BL2022 20V
Charger Display
Green
Product contains Lithium-Ion. Do not dispose of
this product with household waste material.
Rated Capacity Type
3.0 Ah Li-Ion
2.5 Ah Li-Ion
5.0 Ah Li-Ion
Alarm
(Sound)
Red
-
l m
-
l m
Low ♪
m l
Low ♪
2 x ä
m
Low ♪
3 x ä
m
Low ♪
m 4 x ä
Low ♪
5 x ä
m
Low ♪
6 x ä
m
High
l m
♪ ♪ ♪
Li-Ion
47644658001_ed1
Fuel
Gauge
mmmm
ämmm
Ê
mmmm
mmmm
mmmm
mmmm
mmmm
mmmm
llll