Environmental Protection; Symbol Identification - Ingersoll-Rand W3001 Serie Technische Produktdaten

EN
WARNING
Sound and vibration values were measured in compliance with internationally recognized test standards. The exposure to the user in a
specific tool application may vary from these results. Therefore, on site measurements should be used to determine the hazard level in that
specific application.
Lubrication
Remove hammer case to apply lubrication on the anvil, impact mechanism assembly and gears. Apply grease evenly and sparingly. An excessive
accumulation of grease will result in sluggish operation. See drawing 48380273 and table below. Maintenance frequency is shown in a circular arrow
and defined as h=hours, d=days, and m=months of actual use.
2
8h
8h 1
1 2
IR# IR#
105 67
1
8h
1
8h
(Dwg. 48380273)
Task Light
CAUTION
● Task Light is not user serviceable. Repair should only be carried out by an Ingersoll Rand Authorized Service Center. User service may
result in electric shock, fire and or serious personal Injury.
● Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
● The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Parts and Maintenance
Tool repair and maintenance should only be carried out by an Authorized Service Center.
Refer all communications to the nearest Ingersoll Rand office or distributor.

Environmental Protection

When life of Ingersoll Rand electrical product has expired, it must be recycled in accordance with all applicable standards and regulations (local,
state, country, federal, etc.). Improper disposal may endanger environment.

Symbol Identification

Li-Ion
Do not dispose of this product with Product contains Lithium-Ion. Do not dispose of
Return waste material for recycling.
household waste material. this product with household waste material.
Original instructions are in English. Other languages are a translation of the original instructions.
EN-2 TL-W3001-PIM_ed2