Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Figure A
Forward Torque
ft-lb (Nm)
10 (14)
8 (11)
6 (8)
4 (5)
2 (3)
0
Torque values shown in Figures A and B are approximate. Actual torque can be effected by the application and may vary from the values shown in the graph.
Lubrication
Remove hammer case to apply lubrication on the anvil, impact mechanism assembly and gears. Apply grease evenly and sparingly. An excessive
accumulation of grease will result in sluggish operation. See drawing 48380273 and table below. Maintenance frequency is shown in a circular arrow
and defined as h=hours, d=days, and m=months of actual use.
(Dwg. 48380273)
Task Light
● Task Light is not user serviceable. Repair should only be carried out by an Ingersoll Rand authorized service center. User service may
result in electric shock, fire and or serious personal Injury.
● Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
● The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Adjust Brightness and Flashlight Mode
1. To set task light, position directional switch to neutral.
2. Pull trigger to cycle through brightness options or to turn off light.
3. Position directional switch to Forward or Reverse to save desired brightness setting and begin tool use.
Refer to illustration #2 on page 2.
While in neutral, tool will remain in task light mode for 10 minutes.
Parts and Maintenance
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand office or distributor.
Environmental Protection
When life of Ingersoll Rand electrical product has expired, it must be recycled in accordance with all applicable standards and regulations (local,
state, country, federal, etc.). Improper disposal may endanger environment.
Symbol Identification
Return waste material for recycling.
Original instructions are in English. Other languages are a translation of the original instructions.
47621725001_ed4
Hand-tight
M6
M8
M10
M12
Bolt Size
8h
2
1
8h
1
8h
Do not dispose of this product with
household waste material.
Figure B
Forward Torque
ft-lb (Nm)
110 (150)
95 (129)
80 (108)
65 (88)
50 (68)
35 (50)
M10
NOTICE
1
IR#
105
8h
1
CAUTION
NOTICE
Product contains Lithium-Ion. Do not dispose of
this product with household waste material.
Wrench-tight
M12
M14
M16
Bolt Size
2
IR#
67
Li-Ion
EN
EN-2
Werbung
Inhaltsverzeichnis
