Product Operation; Environmental Protection - Ingersoll-Rand R140 Technische Produktdaten

EN

Product Operation

These models feature a variable trigger and an automatic shut-off.
The variable trigger feature allows an operator to regulate the power output of the tool through
manipulation of the trigger lever. Power output will increase as the trigger lever is pressed in,
with maximum power output occurring when the trigger lever is fully depressed. Power output
will decrease as the trigger lever is released.
The automatic shut-off feature shuts off power to the motor when the motor is stalled. When
tightening a fastener, the motor will stall when the tool is unable to tighten the fastener any
further, so automatic shut-off will occur at this condition. When attempting to loosen a fastener,
the motor will stall if the tool is unable to move the fastener, so automatic shut-off will occur at
this condition also. When automatic shut-off occurs, the trigger lever must be fully released and
then pressed again to restart the tool. After automatic shut-off occurs, the tool can continue to
be used as a manually-operated ratchet, provided that the maximum torque limit specified for
that particular model is not exceeded.
Parts and Maintenance
For routine maintenance:
●
Monthly, inject 1 cm
yoke to lubricate the drive bushing.
●
After every 3 months of use, disassemble the ratchet head and lubricate the components with
of Ingersoll Rand #70 grease.
2 cm
3
●
After every 6 months of use, disassemble the gearing and lubricate the components with
of Ingersoll Rand #67 grease.
1 cm
3
All other maintenance and tool repair should only be carried out by an authorized Service
Center. For the nearest location, visit www.irtools.com/locator.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.

Environmental Protection

When the life of Ingersoll Rand electrical product has expired, it must be recycled in accordance
with all applicable standards and regulations (local, state, country, federal, etc.). Improper
disposal may endanger environment.
For European Union countries only:
Ingersoll Rand electrical products and batteries that have reached end of life must be recycled
in accordance with Waste Electric and Electronic Equipment Directive (2002/96/EC).
Ingersoll Rand electrical products and batteries should be returned directly to:
Ingersoll Rand Distribution Centre
Hindley Green
Wigan
Lancashire WN2 4EZ
England
Telephone: +44 (0) 1942 257131
Fax: +44 (0) 1942 526255
EN-2
of Ingersoll Rand #70 grease between the ratchet housing and the
3
80232937_ed6