Seat And Helmet Holder Lock - Ducati MONSTER S4Rs Anleitung- Und Instandhaltungsheft

Seat and helmet holder lock (fig. 20 and fig. 21)
Opening
Insert the key into the lock and turn it clockwise to release
the seat from the frame. Pull the seat backwards to
release it from the front catches.
The helmet cable (1) is located at the rear of the
compartment under the seat (see page 43). Pass the
cable through the helmet and insert the end of the cable
in the pin (2). Leave the helmet hanging and refit the seat
to hold it in place.
Warning
This device protects the helmet against theft when
the motorcycle is parked. Do not leave the helmet attached
in this way when riding the motorcycle, as it can interfere
with your movements and cause loss of control of the
motorcycle.
Closing
Make sure all parts are correctly arranged and secured in
the underseat compartment. Insert the front ends of the
seat base under the U bolt in the frame, then push the
rear end of the seat until you hear the latch in the lock click
into place. Check that the seat is firmly secured to the
frame and remove the key from the lock.
0
1
1
2
E
fig. 20
fig. 21
27