At The End Of A Cleaning Session - Nilfisk-ALTO ATTIX 170 Betriebsanleitung

ATTIX 170 / ATTIX 170 E
■ These operations can only be carried out by
trained and qualified personnel who must wear
adequate clothing, in compliance with the laws in
force.
■ Take care not to raise the dust during this
operation. Wear a P3 protective mask.
■ In case of dangerous and/or toxic dust, use
different kinds of safety bags or ABS containers.
■ The container and/or bag must only be disposed
of by qualified personnel and in compliance with
the laws in force.
How to replace the ABS safety container:
■ Place the vacuum hose in a safe, dust-free place.
■ Release the container (1, Fig. 11).
■ Close the safety container with the supplied cover
and remove it from the dust container (1), fit an empty
container in its place.
■ Start the motor again to prevent dust from being blown
about.
Make sure that the gasket is in perfect condition and
■
correctly positioned.
■ Switch off the motor, fit an empty container in place and
fasten it in position.
Replacement of the safety bag for class H vacuum
cleaners (Fig. 12)
Remove and put the vacuum hose in a safe and dust-
■
free place.
■ Close the inlet by using the relevant cap (1).
■ Release the dust container. Remove the bag making
sure that the union tubular element (3) is kept connected
to the inlet.
■ Close the plastic bag hermetically.
■ Tighten the clamp (2) to close the inlet hermetically.
■ Remove the union element from the dust container inlet.
■ Insert a new safety bag making sure that the bag inlet is
sealed.
I
■ Wrap the plastic bag around the dust container external
wall.
■ Set the dust container into the vacuum cleaner again.
GB
Before inserting the bag, remove the tubular element so
F
that it does not obstruct the input air.
D
E
C328
WARNING!
[ NOTE ]

At the end of a cleaning session

■ Turn off the vacuum cleaner and remove the plug from
the socket.
■ Wind the connection cable around the cable carrier (Fig.
13).
■ Empty the container as described in the "Emptying the
container" paragraph.
Clean the vacuum cleaner as described in the
"Maintenance, cleaning and decontamination" paragraph.
Wash the container with clean water if aggressive
■
substances have been vacuumed.
■ Store the vacuum cleaner in a dry place, out of reach of
unauthorized people.
■ Shut the inlet with the appropriate plug when the vacuum
cleaner is transported or not being used (particularly in
the case of M, H versions) (1, Fig. 13).
10
11/2008