Getting The Best Results - Nilfisk-ALTO SDV 8000 Handbuch

Guidance
Congratulations
We would like to take this
opportunity to thank you for your
purchase of the Nilfisk ALTO
combined steam, detergent and
vacuum cleaner.
The SDV8000 is manufactured
in the EU to the highest quality
Standards
This instruction manual contains
all of the necessary information to
operate and maintain this
machine. Please read this
instruction manual carefully
before you start using or carrying
out any maintenance on the
machine.
If you use this machine correctly
as stated in this instruction
manual this machine will fulfil all
your steam cleaning needs.
This machine is intended for use
in a commercial cleaning
environment. If you do not follow
the instructions contained in this
manual, situations may arise
which may be dangerous or
harmful to the machine or the
person operating the machine.
Read this manual carefully so that
you know when such situations
can arise.
Ensure that all operators of this
machine are fully trained on how
it works.
Report any problems or damage
to the machine immediately to the
supplier or a Nilfisk ALTO
approved supplier for this
product. Do not operate the
machine until the problem or
damage has been resolved.
English

Getting the Best Results

Operate the machine in
accordance with the instruction
manual.
Maintain the machine in
accordance with instruction
manual.
Use only parts supplied by Nilfisk
ALTO approved distributors.
Use only detergents and cleaning
products in the solution tank
which have been approved by
Nilfisk ALTO.
Keep this manual in a safe
place for future reference
and ordering of spare parts
Installation
Lift the machine out
of the box.
Carefully place the
machine on its side in order to
assemble the wheels securely.
A flat surface is required which
will not scratch or damage the
surfaces of the machine.
Diagram D – Back wheel
assembly.
Using a 10 mm spanner remove
the bolts from the machine and
place the assembly into place
towards the back of the machine.
Tighten the bolts securely
ensuring no movement on the
brackets.
Diagram D – Casters with Brake
x 2.
Remove bolts from the machine
and position into place towards
front of the machine. Tighten
securely ensuring no movement
on the brackets.
Once all the wheels are fully
assembled, resume the machine
to its upright position.
Place Tubular Handle (Diagram
D) in position on the back of the
Page 5
machine and secure using the 4 x
Plastic Wing Nuts (Diagram D).
Do not screw them all the way
in at this point.
Place Wire Basket (Diagram D)
over the Wing Nuts and tighten
up to secure.
Check all accessories are present
in the box as shown in Diagram
C & D.
Warnings
This machine has been
designed with your safety in
mind; however it is
important that you observe
the following points for safe
operation during the
operating procedure
This is an electrical product – Do
not use in wet weather or allow
the machine to get wet.
Do not discharge steam towards
people, danger of scolding. Or
towards equipment containing
electrical components.
Never allow children to play with
this appliance.
Do not use the machine for other
purposes that it was built for.
Please remember that the steam
cleaner operates at temperatures
in excess of 170°C. Never use it
on objects, which cannot resist
the temperature (delicate
materials, fabrics, plastics, wood
etc). Where any doubt exists
check carefully on a part of the
material where minor marks will
not matter.
Do not operate the machine or
carry out any maintenance out on
it.
- Unless you are trained
and authorised to do so.
- Unless you have read
and thoroughly
understand this
instruction manual.