Programme Progression - Compex Energy Mi-READY Bedienungsanleitung

Adjusting stimulation energies
W hen you start a programme, you will be
prompted to increase the stimulation
energies. This is critical to the success of
any treatment. To find out what energy
Programme time in
minutes and seconds
The animated rising
convection symbol
represents the
warming-up
sequence
6a Press the On/Off button to place the unit in
Pause mode.
6b c d e The Compex "bleeps" and the
symbols of the four channels flash, changing from
+ to 000: the four channels are at 000 energy.
You must increase the stimulation energy so that
the stimulation can start. To do this, press the +
buttons for the relevant channels until the
desired setting is reached. If you want to
increase the energy level of all four channels
simultaneously, press the "i" button, located
below the On/Off button. Press the "i" button
twice to increase the levels in the first 3
Remaining time (in
minutes and
seconds) before
the end of the
programme
7a Press the On/Off button to interrupt the
programme momentarily To restart it, simply
press the channel 4 +/- button. The session will
resume at 80% of the energy levels that were in
use prior to the interruption.
7 b c d e The different energies reached
during the contraction phase are shown by a
series of black bar graphs. Active rest phase
energies are shown by hatched bar graphs.
162
level needs to be reached for each
programme, refer to the applications
menu.
channels, and 3 times to increase the levels in
the first 2 channels. When you press the "i"
button, the associated channels are highlighted in
white on a black background.

Programme progression

timulation actually starts when the
S
stimulation energy has been increased.
The examples reproduced below are
sufficient to understand the general rules.
Session sequences
Warm-up Work period
N.B.: Active rest phase stimulation energies
are automatically set at 50% of contraction
energies. These can be modified during the rest
phase. Once modified, they will be totally
independent of the contraction energies.
Session progression scale.
For details on how it works,
see the following section:
"Programme progression"
Relaxation
Time bar showing
contraction time and active
rest time is shown only
during the work sequence