End Of Programme; Consumption And Recharging - Compex Energy Mi-READY Bedienungsanleitung

N.B.: If your Compex emits a beeping sound
and the symbols under the active channels
begin to flash, the stimulator is suggesting you
increase the level of the stimulation energies. If
you are working at the maximum tolerance level,
simply ignore this message.

End of programme

A t the end of each session, a small flag
will be displayed on the screen and a
short melody will be played. To switch off
the stimulator, press the On/Off button.
8. Consumption and
recharging
Never recharge the stimulator
without first disconnecting the stimulation
cables.
Always use the charger supplied by
Compex to recharge the batteries.
he Compex runs on rechargeable
T
batteries. The battery's life depends on the
programmes and stimulation energy used.
e strongly recommend you fully charge
W
the battery before using your Compex for
the first time as this will improve its
autonomy and life span. If you do not use
your device for a long period of time,
please recharge the battery regularly.
Electricity consumption
The charge state of the battery is
indicated by a small battery icon on the
screen.
I f the battery icon contains just two lines,
this means that power is running low.
Stop the session and recharge the unit.
I f the symbol normally displayed
above the channel 4 +/- button is not
visible and if the battery icon is flashing,
this means that the battery is completely
discharged. It is no longer possible to use
the device. Recharge immediately.
Recharging
emove all stimulation cables from the
R
stimulator before recharging it. Connect
the charger to the mains and then connect
the stimulator to the charger. The charge
menu shown below will automatically
appear on the screen.
163