lamber DSP1 Installation Bedienung Seite 19

WASHING
4
- Put the basket into the machine.
Close the door and push the button "B".
(NB: as regards DSP5 model, the cycle starts
when the hood is closed).
The lamp "F" stays ON without blinking and it
indicates that the cycle has begun.
The cycle will start for 2 minutes, including,
besides the washing, a five seconds stop and the
rinsing of 18 seconds (23 seconds for machines
with Water softener) with clean water at 85°-
90°C will start.
Once the cycle has ended, the lamp "F" restarts
blinking.
5
- At the end of the cycle open the door and
pull out the basket.
NOTE. STOP CYCLE function: the washing cycle can
be stopped if you push again the cycle pushbutton
"B" (light "C" flashing now) :
to restarting washing cycl push again button "B".
WARNING! Do not open the dishwasher door
durino the washing cycle.
In case of accidental opening the cycle stops. If You
close the door, the cycle starts again from the point
where it had stopped.
At the end of the cycle open the door and pull out the
basket.
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. Any
halos might be caused by an insuffucuent
rinsing: in this case, check that the rinsing jets
are clean and there is a sufficient pressure in
the water distribution network.
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are
correct.
DISHES POSITIONING
It is suitable to place dishes, inside the plastic
basket with the concave side facing upwards.
Place mixed cutlery in a vertical position into
the suitable container minding not to cram them
and whit handgrips towards the bottom (see
draw).
It is suitable to place glasses, inside the plastic
basket with the concave side towards the
bottom. Place mixed cutlery in a vertical
position into the suitable container minding not
to cram them and with hafts towards the bottom
(see draw).
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3 Afterwards push button "B" for 3 seconds.
(the lamp "H" is lighted).
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
(see also the paragraph "Day maintenance" ).
19