Know Your Unit; Assembly Instructions; Attaching And Removing The Blower/Vacuum Tube - Ryobi RGBV3100 Benutzerhandbuch

KNOW YOUR UNIT

APPLICATION
As a blower;
• Cleaning of yards, garages, driveways, porches,
patios, around walls, fences, etc.
As a vacuum;
• Picking up leaves, light debris, etc.
Blower/Vacuum Inlet
Blower Outlet
ATTACHING AND REMOVING THE BLOWER/
VACUUM TUBE
Attaching
NOTE: The Blower/Vacuum Tube comes un assembled
on this unit. Installation is required to provide
safe and easy use for the operator.
1. Remove the screws and nuts provided from the
hardware pack.
2. Insert the blower/vacuum tube all the way into the
opening on the motor housing until the holes in the
tabs on the blower/vacuum tube align with the screw
holes in the housing (Fig. 1).
6
RULES FOR SAFE OPERATION
Blower/Vacuum Tube
Vacuum Bag Hook
Blower/Vacuum Mode
Change-Over Lever
Choke Lever
Primer
Air filter/muffler cover

ASSEMBLY INSTRUCTIONS

Throttle Lever
Fuel Cap
Ignition Switch
3. Insert the 2 (two) 8-32 x 3/4" slotted T20 Torx screws
into the right side of the motor housing and the 2
(two) nuts into the left side of the motor housing
(Fig. 2).
4. Tighten the screws firmly. Do not over-tighten.
5. Install the 2 (two) remaining self-tapping 8-16 x 3/4"
slotted T20 Torx screws into the holes on either side
of the housing (Fig. 2). Tighten until snug, do not
over-tighten.
Starter Rope
Grip
Harness
Spark Plug
Vacuum Bag
Vacuum Bag Zipper