INVENTOR U5MRSL322-18 Installationshandbuch Seite 22

Model C
1(A) 2(A) 3(A) 1(B) 2(B) 3(B) 1(C) 2(C) 3(C) 1(D) 2(D) 3(D) 1(E) 2(E) 3(E)
TO B
TO A TO C TO D
Model E
CAUTION
circuit diagram posted on the inside of the control cover.
transporation. Because loose screws may cause wire burn-ou, check that the screws are tightly
fastened.
marked on the name plate.
Always install an earth leakage circuit breaker in wet or moist areas.
The following can be caused by a drop in voltage: vibration of a magnetic switch, damaging
the contact point, broken fuses, and disturbance of normal functioning.
an air gap contact separation of at least 3mm in each active (phase) conductors.
Before accessing terminals, all supply circuits must be disconnected.
NOTE: To satisfy the EMC compulsory regulations, which is required by the international standard
correct magnetic rings on your equipment according to the wiring diagram that adhere to
the your equipment .
Please contact your distributor or installer to get further information and purchase
magnetic rings (The supplier of magnetic ring is TDK （ model ZCAT3035-1330 ） or similar) .
ƒPage 22
„
TO E
Model D
L(A) N(A) S(A) L(B) N(B) S(B) L(C) N(C) S(C) L(D) N(D) S(D) L(E) N(E) S(E)
TO C TO D TO E
TO A TO B
Model F