Safety Instructions; Use And Maintenance - Refsta Andro I Bedienungs- Und Montageanleitung

hood is installed.
N.B. The Clean Air Function program
activation shall be performed with the hood
motor off.
_Clean Air activation: press - and + keys
simultaneously for 3 seconds.
The program starts the motor at second
speed for 10 minutes every hour, for 5
cycles.
_Active program confirmation: functions
activation is confirmed by the recycle
symbol on the display.
_Program deactivation before set time:
press - and + keys simultaneously for 3
seconds; the program is deactivated and
the hood is turned off.

SAFETY INSTRUCTIONS

In certain circumstances electrical
appliances may be a danger hazard.
• The hood has been designed to remove
the kitchen smells; any other additional use
shall be regarded as non-intended.
• Aerate the room if other appliances that
are not supplied by electrical power are
being used while the hood is on.
• Do not leave the cooker on if it is not being
used.
• Do not flambé food directly under the
cooker hood to prevent the grease filter
catching fire due to flames.
• Constantly check food frying to avoid
that the overheated oil may become a fire
hazard.
• Do not check the status of the filters while
the cooker hood is operating.
• Do not touch the light bulbs after
appliance use.

USE AND MAINTENANCE

It is recommended to switch on the
appliance before cooking. It is also
recommended to leave the appliance in
operation for 10 minutes after cooking is
terminated in order to completely eliminate
cooking vapours and odours. The proper
function of the cooker hood is conditioned
by the regularity of the maintenance
operations, in particular, the active carbon
filter.
Clean the fan and other surfaces of the
cooker hood regularly using a cloth
moistened with denatured alcohol or non
abrasive liquid detergent.
WARNING: unplug the appliance or switch
off the circuit breaker before carrying out
maintenance operations.
METAL ANTI-GREASE FILTERS (Fig.2M)
The metal anti-grease filters capture the
grease particles of the vapours that develop
during cooking, therefore they are subject
to clogging according to the frequency of
the use of the appliance.
In order to prevent fire hazard, it is
recommended to clean the filter every
2 months by carrying out the following
instructions:
• Remove the filters from the cooker hood
and wash them in a solution of water and
neutral liquid detergent, leaving to soak.
• Rinse thoroughly with warm water and
leave to dry.
The filters may also be washed in a
dishwasher.
The aluminium panels may alter in colour
after several washes. This is not cause for
customer complaint nor replacement of
panels.
ACTIVATED CARBON FILTERS (Fig.2L)
optional - recirculating mode only
The activated carbon filters purify the
kitchen vapours, the air is then conveyed
back into the kitchen.
The saturation of the active carbon filter
depends on the frequency of use of the
appliance, by the type of cooking and the
regularity of cleaning the anti-grease filters.
The filters are not washable nor re-useable
and must be replaced at maximum every
four months.
To assemble the carbon filter it is necessary
to:
- remove the metal anti-grease filters
(Fig.2M)
- rotate the 2 carbon filters to remove them
(Fig.4)
6