Refsta Andro I Bedienungs- Und Montageanleitung Seite 5

locking it in with the appropriate screws in
the drill holes of the bracket Z previously
affixed to the wall (fig.9).
RECIRCULATING MODE INSTALLATION
In order to transform your cooker hood
from the exhaust version to the recirculating
version, ask your local retailer for the
recircultating kit and then carry out the
enclosed installing instructions.
ELECTRICAL CONNECTION
Check that the mains voltage complies
with the that required by the hood. This is
indicated on the plate that is applied inside
the appliance.
OPERATING CHECKS
Check lights and motor start-up on all 4
speeds.
USE INSTRUCTIONS
Version with TOUCH CONTROL on
glass (Fig.1)
ON/OFF _ turns on the hood at
0 speed , and turns off the hood
(lights included)
Key – Starts the hood at 1°
speed (decreases speed and
brings the hood back to ON).
+ key. Increases speed from 2°
to 3° to 4° speed
NOTE: speed increase starts
from 1° Speed.
Timer – the timer is activated by
pressing this key, and the motor
is turned off after 15 minutes.
When operation speed is set
at 4 speed , the timer activates
automatically and the speed is
automatically set at 3 speed
after 7 minutes.
Timer programs stop: by
pressing the "TIMER" key or
increasing/decreasing + OR -
keys, the timer programs are
deactivated.
Light (only when the hood is
ON)
Display
TIMER
_Timer activation for 1°_2°_3° speed,
press the timer key: aspiration turns off
automatically after 15 minutes.
_Active function signal: 1°_2°_3° speed will
flash on the display.
_ "TIMER" programs deactivation: press
the "TIMER" key
_ "TIMER" programs deactivation and
activation for 1°_2°_3°_4° basic speed: by
selecting the decrease/increase
keys - or +.
_ Timer function activation for 4° speed:
the timer is activated automatically.
The speed will be automatically set at 3°
speed after 7 minutes.
FILTER WARNING LIGHT "F" DISPLAY
Grease filter cleaning and maintenance
warning light.
This function reminds you to clean and
maintain the grease filter of your hood.
_This function activates after 30 hours
operation of your hood, and is confirmed
by the letter F on the display when the hood
is off.
This function is temporarily deactivated
when the hood is turned on and the light
key flashes again when the hood is off.
_ Function reset, press the light key for 3
seconds.
N.B. Warning deactivation shall be
performed when the hood is off.
CLEAN AIR FUNCTION
Clean air program
This program allows to filter the saturated
air in the kitchen environment, where your
5