Power Indicator - Panasonic AW-HE870E Bedienungsanleitung

Major operating controls and their functions
UP/ABB switch [UP/ABB]
The item just above can be selected by pressing this
switch while the menu is displayed.
When this switch is pressed while an item is able to be
changed on a sub menu screen, the value is adjusted
higher.
When the menu is not displayed or the camera is in
shooting mode, the automatic black balance control
(ABB) can be set with this switch.
DOWN/BAR switch [DOWN/BAR]
The item just below can be selected by pressing this
switch while the menu is on the screen.
When this switch is pressed while an item is able to be
changed on a sub menu screen, the value is adjusted
lower.
When the menu is not displayed, the colour bar and the
shooting conditions are indicated by pressing the switch
for about 2 seconds.
 Video output connector [VIDEO OUT]
A composite video signal is provided at this connector.
(1 V [p-p], 75 j BNC connector)
 Iris connector [IRIS]
Connect the IRIS cable of the motor drive lens (such
as the AW-LZ17MD9AG and AK-LZ20M85G) to this
connector.
 I/F Remote connector [I/F REMOTE]
This connector is used to connect the remote operation
panel (AW-CB400) or pan-tilt head (such as the
AW-PH400).
If the AW-CB400 is to be connected to this connector, a
camera control cable (AW-CA50T8) is required.

 Power indicator

Green LED lamp lights to indicate that the specified DC
power is supplied to the DC 12 V input connector .
- 15 (E) -