LIVARNO LUX LSLB 20 A1 Bedienungsanleitung Seite 12

LIVARNO LUX LSLB 20 A1
Push the prepared connecting cable from
behind through the rubber seal of the cable
bushing.
Pierce the pre-cut mounting holes and then mark
the position of the drill holes on the wall so that
you can then drill the wall. Insert the dowels
(14) into the drilled holes.
Now screw in the screws (13) to fix the
mounting plate (7) securely to the wall.
Now wire the connecting cable correctly into the
lug (9) on the mounting plate (7). When doing
so, observe the marking on the individual
terminals. Also account for Figure [B] on the
cover page.
DANGER! If the colour coding on
your connecting cable differs from
the illustration opposite, the
connecting cable must be measured
by a qualified electrician and the
configuration of the individual wires
determined.
10 - English
Symbol
N
L
Wire
blue
yellow/green
brown