CONDTROL Super RotoLaser Bedienungsanleitung Seite 8

CONDTROL Super RotoLaser
EN
ROTARY LASER
upper line. Press button
of axis X. To switch to value of tilt angle for axis Y press button
Y value will flash. Press button
required value of axis Y. Confirm the setting by pressing button
Symbol on the display as well as laser beam will flash until
rotary head assumes target position.
Then rotary head starts rotating at 600 rpm.
Tilt function is active in this mode. If the product is unbalanced by
some external influence, it will not perform self-levelling again. You
will hear sound signal, symbol
To build inclined planes again press button
values of X и Y are preserved.
Manual mode
This mode allows construction of laser planes at any angle inclination.
Place the product on a solid and flat surface. Turn on the product.
Laser beam as well symbol
soon as self-levelling is finished rotary head starts rotating clockwise
at 600 rpm. Press and hold button
product will enter manual mode, symbol
display. Install the product at required angle and fix its position.
To exit manual mode press and hold button
Manual mode indication
14
user manual
and to set up required value
and to set up
will appear on the display.
. Previously set up
on the display are flashing. As
during 5 seconds. The
will appear on the
for 5 seconds.
will turn off.
EN
ROTARY LASER
Top and bottom plumb dots
The product allows working with top and bottom plumb dots (zenith,
,
nadir). They are on in any operation mode of the product.
.
Rotation speed
Speed 600 rpm is default. Press button
speeds of rotary head. Rotation speeds change in the following way:
600-0-60-120-300-600 rpm.
Attention! The slower rotation speed, the brighter laser beam.
Scan mode
Scan mode allows seeing laser line at long distance.
Press button
By series press on button
10°; 45°; 90°; 180°.
Appropriate symbol appears on the display
Press button
- clockwise. To exit scan mode press
will start rotating.
CONDTROL Super RotoLaser
to switch between
to activate scan mode.
choose required scan sector – 0°,
to move scan sector counterclockwise, button
user manual
.
. Rotary head
15