CONDTROL Super RotoLaser Bedienungsanleitung Seite 10

CONDTROL Super RotoLaser
EN
ROTARY LASER
5. If distance between points X1 и X3 is more than 2 mm – turn off the
product and contact service center.
Axis Y
1. Place the product at 0.5 m distance from one wall and 10 m
distance from another wall, so that axis Y is aimed at the wall.
2. Turn on the product. As soon as self-levelling is finished, mark
location of laser line on both walls by points Y1 and Y2.
18
EN
ROTARY LASER
user manual
3. Turn off the product. Move it to the opposite wall, position of the
product should remain unchanged.
4. Turn on the product. Align laser line with the previously made
point Y2. Mark point Y3 on the opposite wall.
5. If distance between points Y1 и Y3 is more than 2 mm – turn off
the product and contact service center.
CONDTROL Super RotoLaser
user manual
19