Charging The Trimmer - Panasonic ER-RZ10 Bedienungsanleitung

Charging the trimmer

• Make sure that the trimmer is turned off.
1
Connect the appliance
plug to the stand socket.
2
Place the trimmer on the
charging stand.
3
Insert the adaptor into a
household outlet.
• Check that the charge status
lamp ( ) glows.
• Charging is completed after
approx. 1 hour.
4
Disconnect the adaptor when the charge status
lamp stops glowing.
(for safety and to reduce energy usage)
<To check if charging is completed>
If you remove and reinsert the appliance plug while charging,
the charge status lamp glows and turns off after
approximately 5 seconds.
Notes
• If there is crackling noise on radios or other devices while
charging, charge the trimmer using a different household outlet.
• When the appliance is not used for 6 months or more, the battery
will weaken (leak battery fluid, etc.). Fully charge the battery
once every 6 months.
• When charging the trimmer for the first time or when it has not
been in use for more than 6 months, the lamp on the main body
may not glow for a few minutes, or the operating time may
shorten. Please charge it for more than 8 hours in such cases.
10
ER-RZ10_EU.indb 10
• Recommended ambient temperature for charging is 0 °C – 35 °C.
The charging time may change or battery performance may
decrease outside of the recommended temperature.
• A full charge supplies enough power for approximately
50 minutes of use. (When used on dry hair under 20 °C to 30 °C
environment for 20 minutes, once a week)
3 3
The operating time may differ depending on the frequency of
use, the operating method and the ambient temperature.
• You can charge the battery before it is completely discharged.
2
2
However, it is recommended to charge when the battery is
completely discharged. The battery life depends strongly on
factors such as how it is used and stored.
1
1
Charging without the charging stand
1. Press the power switch to turn off the power, and
insert the appliance plug into the trimmer.
2. Plug in the adaptor into a household outlet.
AC operation
If you connect the AC adaptor to the trimmer in the same way as
for charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly
or stop, even with the AC operation. In this case, charge the
battery for 1 minute or more.
• The battery will be discharged, even with the AC operation.
2017/01/13 11:02:01