Using The Trimmer; Care - Panasonic ER-RZ10 Bedienungsanleitung

Using the trimmer

• Check that the blades are not damaged or deformed before use.
• Apply the oil to the trimmer before and after each use.
(See page 12.)
• When you finish using the trimmer, turn it off.
• The appliance may not operate in an ambient temperature lower
than approximately 0 °C.
Press the power switch to turn on the power.

Care

• Make sure that the trimmer is turned off.
Removing and mounting the blade
Removing the blade
Hold the trimmer and push the
blade with your thumb.
Mounting the blade
Fit the mounting hook (B) into the blade mounting (A) on the
trimmer and then push in until you hear a click.


ER-RZ10_EU.indb 11
Cleaning
• Clean the trimmer and the blade after each use.
(If not cleaned, the motion will become poor and the sharpness
will worsen.)
• Remove the blade. (See this page.)
►With water
• Do not wash the appliance with water.
Doing so may cause malfunction if put in water.
Blade
1. Clean the blade with running water.
• Rinse with water and shake up and
down several times to remove the water.
2. Wipe off the water with a towel and let it
dry naturally.
3. Apply the oil to the blade after drying.
(See page 12.)
►With the brush
Main body and blade
1. Brush off any hair trimmings from the
main body and from around the blade.
2. Brush off the hair trimmings from the
blade edge.
3. Brush any hair trimmings out from
between the stationary blade and the
moving blade while pressing down the
cleaning lever (a) to raise the moving
blade.
4. Apply the oil to the blade.
(See page 12.)

11
2017/01/13 11:02:01