Led Indicators - GUTMANN LLANO EM 32 Bedienungsanleitung

EN
Operation via Switch
(Located on the Ceiling Device below the Pane)
Pressing the switch to the left (1) :
Light ON/OFF
Longer push results in dimmed light (not
with LED).
Pressing the switch to the right (2):
fan ON
The filter saturation display is also reset
using this switch. To do so, press the
switch to the right until the red LED
turns off.
Pressing the switch to the right for 3
seconds: hood is turned off.
Regulation of the power level
Push switch (3) at the right side + sym-
bol: higher fan performance
P u s h s w i t c h
lower fan performance
In certain cases switch allocation can
differ from the photo due to specific
customer requirements.

LED Indicators

(Located on the Ceiling Device)
Information regarding the operating
conditions of the hood can be read on
the device's LED indicators:
Indicators
Cool Down
Level 1
Level 2
Level 3
Intensive Level
Filter Saturation Indicator
LED 1: Indicates operational status:
ON/OFF
LED 1 blinking: Indicates automatic cool
down period (the hood will automatically
decrease by one power level every 5
minutes until it finally turns off)
LED 2: Power level 1 (lowest motor
speed), press button 2 on the remote
control once
LED 3: Power level 2 (middle motor
speed)
16
( 4 ) – s y m b o l :
green LED
green LED
green LED
green LED
green LED
red LED
Press button 2 on the remote control
twice
LED 4: Power level 3 (high motor
speed) Press button 2 on the remote
control three times
LED 5: Intensive level (motor automati-
cally returns to level 3 after 5 minutes)
Press button 3 on the remote control
LED 6: Filter Saturation Indicator
The metal filter must be cleaned when
the red LED lights up (see section on
cleaning and care).
Button min. 10 sec.
pressures to a red
LED goes off !