Procedure To Connect The Serial And I/O Ports To An External Cable - Agilent Technologies TV 801 Navigator Bedienungshandbuch

17 Technical Information

Procedure to Connect the Serial and I/O Ports to an External Cable

Procedure to Connect the Serial and I/O Ports to an
External Cable
In the following picture, it has showed the right procedure to connect
a cable to the I/O or to the serial port.
A shielded cable has to be utilized. Remove the plastic protection on
both the ends of the cable (picture b) and after it is necessary to
connect the wires to the single pins like showed in the picture c.
Take care to have a good contact between the metallic case and the external
NOTE
shield of the wire. Moreover, this operation has to be done at least on the
controller side.
In this way, you will be sure to reduce the influence of the external
noise and to accomplish the EMC requests. In picture d is showed the
cable assembled.
Figure 21
228/252 TV 801 Navigator User Manual / 87-900-953-01 (G)