Product Markings; U.s. & Canadian Approval - Mettler Toledo IND560 Serie Bedienungsanleitung

If a signal cannot be classified as non-incendive, follow the electrical regulations
for the country of installation for specific wiring requirements of incendive
equipment in a Division 2 or Zone 2/22 area.

Product Markings

Due to special conditions associated with the approval of the IND560xx terminal to
U.S. and Canadian standards as well as ATEX directives, not all models of the
IND560xx terminal are marked in exactly the same way.
When ordering an IND560xx terminal, it is important to know which approval
markings are required. Please have this information available for the local
authorized METTLER TOLEDO sales representative.
IND560 models that have Division 2 or Category 3 certification for use in Division
2 or Zone 2/22 areas are referred to as "IND560xx".
U.S. & Canadian Approval
The panel-mount version of the IND560xx terminal has been approved by UL for
use in Division 2 and Zone 2/22 areas and includes the following markings:
SUITABLE FOR USE IN CL I, GP A-D, DIV 2; CL II, GP F,G, DIV 2; CL III; CL I
ZONE 2 GP IIC (US ONLY); CL II ZONE 22 (US ONLY) LOCATIONS WHEN
INSTALLED PER METTLER TOLEDO DRAWING 72186884CR.
-10° C ≤ Ta ≤ +40° C Temperature ID = T4 (135° C)
The panel-mount version must be installed in a nationally recognized test
laboratory approved, dust-tight enclosure appropriate for the environment.
The harsh enclosure version of the IND560xx terminal has been approved by UL
for use in Division 2 and Zone 2/22 areas and includes the following markings:
SUITABLE FOR USE IN CL I, GP A-D, DIV 2; CL II, GP F,G, DIV 2; CL III; CL I
ZONE 2 GP IIC (US ONLY); CL II ZONE 22 (US ONLY) LOCATIONS WHEN
INSTALLED PER METTLER TOLEDO DRAWING 72186884CR.
-10° C ≤ Ta ≤ +40° C Temperature ID = T4 (135° C)
All approved versions must be installed per METTLER TOLEDO control drawing
72186884CR.
IND560xx Terminal Division 2 and Zone 2/22 Installation Manual
IN ORDER TO INSTALL THE IND560xx TERMINAL UTILIZING THE
U.S./CANADIAN APPROVAL, METTLER TOLEDO CONTROL DRAWING
72186884CR MUST BE FOLLOWED WITHOUT EXCEPTION. IN ORDER TO
INSTALL THE CATEGORY 3 MARKED IND560xx TERMINAL UTILIZING THE ATEX
APPROVAL, THE INSTALLATION DRAWING 30051067R AND THE APPROVAL
CERTIFICATE DEMKO 07ATEX0514991X AND ALL LOCAL REGULATIONS
MUST BE FOLLOWED WITHOUT EXCEPTION. FAILURE TO DO SO COULD
RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
WARNING
1-3