Mettler Toledo IND560 Serie Bedienungsanleitung Seite 10

WARNING
MODELS OF THE IND560 TERMINAL THAT ARE NOT FACTORY-
LABELED AS DIVISION 2 APPROVED OR MARKED AS EUROPEAN
CATEGORY 3 MUST NOT BE INSTALLED INTO A DIVISION 2 OR
ZONE 2/22 ENVIRONMENT.
WARNING
IN ORDER TO INSTALL THE IND560xx TERMINAL UTILIZING THE
U.S./CANADIAN APPROVAL, METTLER TOLEDO CONTROL
DRAWING 72186884CR MUST BE FOLLOWED WITHOUT
EXCEPTION. IN ORDER TO INSTALL THE CATEGORY 3 MARKED
IND560xx TERMINAL UTILIZING THE EUROPEAN APPROVAL THE
INSTALLATION DRAWING 30051067R AND THE EUROPEAN
APPROVAL CERTIFICATE DEMKO 07ATEX0514991X AND ALL
LOCAL REGULATIONS MUST BE FOLLOWED WITHOUT EXCEPTION.
FAILURE TO DO SO COULD RESULT IN BODILY HARM AND/OR
PROPERTY DAMAGE.
WARNING
THE IND560xx TERMINAL MUST BE INSTALLED AND MAINTAINED
PER THE SPECIAL CONDITIONS LISTED IN CHAPTER 2 OF THIS
MANUAL WITHOUT EXCEPTION. FAILURE TO DO SO COULD RESULT
IN BODILY HARM AND/OR PROPERTY DAMAGE.
WARNING
IF THE KEYBOARD, DISPLAY LENS OR ENCLOSURE IS DAMAGED
ON A DIVISION 2 APPROVED OR CATEGORY 3 MARKED IND560xx
TERMINAL THAT IS USED IN A DIVISION 2 OR ZONE 2/22 AREA,
THE DEFECTIVE COMPONENT MUST BE REPAIRED IMMEDIATELY.
REMOVE AC POWER IMMEDIATELY AND DO NOT REAPPLY AC
POWER UNTIL THE DISPLAY LENS, KEYBOARD OR ENCLOSURE HAS
BEEN REPAIRED OR REPLACED BY QUALIFIED SERVICE
PERSONNEL. FAILURE TO DO SO COULD RESULT IN BODILY HARM
AND/OR PROPERTY DAMAGE.
WARNING
THE INTERNAL DISCRETE I/O RELAY OPTION #71209093,
#22015564 OR #22015536
IND560xx TERMINAL INSTALLED IN AN AREA CLASSIFIED AS
DIVISION 2 OR ZONE 2/22. FAILURE TO COMPLY WITH THIS
WARNING COULD RESULT IN BODILY HARM AND/OR PROPERTY
DAMAGE.
WARNING
DO NOT INSTALL, DISCONNECT OR PERFORM ANY SERVICE ON
THIS EQUIPMENT BEFORE POWER HAS BEEN SWITCHED OFF OR
THE AREA HAS BEEN SECURED AS NON-HAZARDOUS BY
PERSONNEL AUTHORIZED TO DO SO BY THE RESPONSIBLE
PERSON ON-SITE.
MUST NOT BE USED IN AN