Hatco Toast King Installations- Und Bedienungsanleitungen Seite 5

WARNINGS
This appliance is not of jet-proof construction. Do not use
jet-clean-spray to clean this appliance.
For safe and proper operation, the unit must be located
at a reasonable distance from combustible walls
and materials. If safe distances are not maintained,
discoloration or combustion could occur. Do not locate
toaster under shelving or closer than 31 cm (12") from
the ceiling.
If service is required on this unit, contact your Authorized
Hatco Service Agent, or contact the Hatco Service
Department at 800-558-0607 or 414-671-6350;
fax 800-690-2966 or International fax 414-671-3976.
This product has no "user" serviceable parts. To avoid
damage to the unit or injury to personnel, use only
Authorized Hatco Service Agents and Genuine Hatco Parts
when service is required.
Genuine Hatco Replacement Parts are specified to operate
safely in the environments in which they are used. Some
aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely
in Hatco equipment. It is essential to use Hatco Replacement
Parts when repairing Hatco equipment. Failure to use Hatco
Replacement Parts may subject operators of the equipment
to hazardous electrical voltage, resulting in electrical
shock or burn.
IMPORTANT SAFETY INSTRUCTIONS
When setting up the unit for operation, make sure power
to the unit is off and the toaster is at room temperature.
Failure to do so could result in personal injury.
Some exterior surfaces on the unit will get hot. Use caution
when touching these areas to avoid injury.
Be sure baskets are cool before removal. If not cool, baskets
could cause burns.
Do not lay unit on the side with the control panel or damage
to unit could occur.
Allow a clearance of 3 cm (1") along the sides. Allow
a clearance of 31 cm (12") along the front discharge
to ensure proper operation and safety.
The toasting of coated products such as garlic bread, cheese
sandwiches and sweet rolls is NOT recommended. Residue
will reduce toaster performance and could possibly ignite
inside the toaster.
Do not locate the toaster in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to the unit. Do not place
toaster in an area that restricts air flow around the motor
compartment. Do not place toaster in direct discharge path
of air conditioning vent or makeup air vent.
Maximum Product Thickness: 3 cm (1-1/4"). Toasting
of thicker products is NOT recommended. Products thicker
than 3 cm (1-1/4") will cause the conveyor system to jam
which could possibly ignite product inside the toaster.
Abrasive cleaners could scratch the finish of your toaster.
Misalignment of the baskets will cause the conveyor to jam.
If hold down bars are separated from the baskets, be sure
the bars are not reversed when re-installed. Hold down bar
stops should be at the left with bar flat on basket.
Incorrectly positioned bars will cause the conveyor to stop.
Failure to lubricate the rear motor bearing as recommended
will reduce the operating life of the motor and possibly void
the warranty.
4
CAUTIONS
CAUTIONS
Form No. TR/TKCEM-0902