Driving The Tractor; Pushing The Tractor By Hand - Viking MT 880 Gebrauchsanleitung

H
J
A

Driving the tractor

1. Sit in the seat and adjust the seat so that you can
comfortably reach all controls and see the dashboard
display.
2. Engage the parking brake (C).
3. Make sure the PTO (B) is disengaged.
4. Start the engine (see "Starting the engine").
5. Disengage the parking brake (C) and release the
brake pedal (D).
6. Depress the forward ground speed control to travel
forward. Release to stop. Note that the further down
the pedal is depressed, the faster the tractor will travel.
7. Stop the tractor by releasing the ground speed
controls, setting the parking brake and stopping the
engine (see "Stopping the tractor and engine").

Pushing the tractor by hand

1. Disengage the PTO and turn the engine off.
2. Move the transmission release lever (K) to the release
position (see "Transmission release lever").
3. The tractor can now be pushed by hand.
Towing the tractor with another vehicle is
not recommended, as the transmission may
be damaged.
B
K
C
D
E
F
Mowing
1. Engage the parking brake (D). Make sure the PTO (B)
is disengaged.
2. Start the engine (see "Starting the engine").
3. Lower the mower deck lift lever (A).
4. Set the cutting height (F) to the desired level.
5. Set the throttle to the full position.
6. Engage the PTO to activate the mower deck.
7. Begin mowing.
8. When the "catcher full" alarm sounds, turn off the PTO
immediately to prevent discharge tube (G) clogging.
Travel to the desired location and empty the catcher.
9. When done mowing, shut off the PTO and raise the
mower deck lift lever. Empty the catcher before storing
the unit.
10.Stop the engine (see "Stopping the tractor and
engine").
To reduce fire hazard, keep the engine, tractor
and mower deck free of grass, leaves and
excess grease.
G
D- 3