List Of The Voice Commands - Clarion NAX963HD Benutzerhandbuch

NAX963HD_280QY5000EA-00_EN.book Page 60 Thursday, May 11, 2006 8:05 PM

List of the Voice Commands

Example of voice command
operation
This section provides an example of the
destination entry by inputting the location stored
in the Adress Book by voice.
1. Press the [VOICE] button.
The announcement for the user to say the
desired command and a beep sound are
heard.
2. Say "Address Book".
When the voice command is recognised, the
List of the Voice Commands
The following table lists the fundamental
command examples which can be input during
the voice input wait mode entered by pressing
the [VOICE] button, classified by the usage.
●Common voice commands available anytime during voice input
These are the commonly usable commands in any condition during the voice input operation.
Operation
Terminates the voice operation, and displays the
current location map screen.
Cancels the immediately precedent voice
operation, and returns to the previous voice input
wait mode.
Displays the next page of voice command list
displayed on the screen.
Displays the previous page of voice command list
displayed on the screen.
Displays the screen displayed when touching the
[ ] key (Voice Help screen).
●Voice commands for changing the map appearance
Say "(Change) map view" ➜ then say the following command.
Operation
Displays the 2D map.
Displays the 3D map.
Displays the 2D/2D maps on the split screen.
Displays the 2D/3D maps on the split screen.
Changes the map orientation to heading up.
Changes the map orientation to North up.
Displays the turn list.
Hides the turn list.
60
NAX963HD
system will respond with a feedback
message, display the list screen of the
Address Book, then enter the voice input
listening mode.
Note:
If you say the voice command before a beep sound
is heard, the voice command cannot be recognized.
3. Say the number of the desired list entry.
The registered place of the number said will
be set as the destination.
Note:
• You can omit the term enclosed by ( ).
• Touching the [ ] key displays the voice
commands usable at that operating condition. You
can refer to them.
Command
"Map"
"Current Position", "Display/Show Map", "Go to
Map", "(Show me) Where am I", "Current Location"
"Back"
"Next (page)"
"Previous (page)"
"(Voice) Help"
"What can I say?"
Command
"2D"
"3D"
"(split screen) 2D (and) 2D"
"(split screen) 2D (and) 3D"
"Heading up"
"North up"
"Turn list on"
"Show turn list"
"Turn list off"
"Hide turn list"