Setting Safety Camera - Clarion NAX963HD Benutzerhandbuch

NAX963HD_280QY5000EA-00_EN.book Page 54 Thursday, May 11, 2006 8:05 PM

Setting Safety Camera

Backing up User Data
You can back up the data currently stored in the
navigation system to USB memory.
Note:
This function saves all data: the data of the Stored
Locations, the route data, the data registered in
Favorite & Frequent List, the setting data of the
Settings menu, and data (wallpaper, Safety Camera)
imported from USB memory.
"Backup of User Data" :
When touching the [Backup] key, a screen with
a confirmation message appears. Operate
according to the guidance on the screen
displayed.
Restoring User Data
You can restore data backed up via USB memory
to the hard disk.
Note:
When you perform backup/restore of data of two
different navigation systems, the stored data on the
restored system will be lost. Be sure to back up data
of the system to restore to before performing the
restore operation.
"Restore User Data" :
When touching the [Restore] key, a screen with
confirmation message appears. Operate
according to the guidance on the screen
displayed.
Setting Safety Camera
Touch the [Safety Camera] key of the Setting menu to set the Safety Camera.
Note:
These settings are enabled when the Safety Camera data is stored in the hard disk.
"Show Icon on Map" :
Turns ON/OFF the Safety Camera Icon display on the map.
"Warning & Sound" :
Turns ON/OFF both of the warning indication and alarm sound when the vehicle gets near a Safety
Camera location.
"Camera Location" :
Touch the [List] key to display the list of the Safety Camera locations. Touching an item of the list
displays the icon at the location of the Safety Camera on the right map.
54
NAX963HD
Resetting to the Factory
Settings
You can return the navigation system to the
status after purchase.
Note:
When the system is reset to the factory settings, all
stored data is erased. It is recommended that you
backup all data you want to keep.
"Reset to Factory Setting" :
When touching the [Reset] key, a screen with
confirmation message appears. Operate
according to the guidance on the screen
displayed.
Screen Adjustment
The position and sharpness of the displayed
screen can be adjusted.
"Screen Adjustment" :
After touching the [Adjust] key, adjust the screen
position by touching the [J], [K], [j] and [k] key.
Touch the [1] or [2] key to select a setting at
which the screen is displayed clearly.
➜
"Safety Camera" (P. 53)