Auto Power Function - Silvercrest SBTF 10 D4 Bedienungsanleitung

Auto power function

The auto power function enables you to set the device so
that it switches back on automatically and connects to a
known mobile phone as soon as the built-in vibration sensor
is activated. If the device has lost its connection to a mobile
phone, e.g. due to excessive distance, and it has not been
restored within 10 minutes, it will switch to auto power
function (if this has been previously activated).
If there is a vibration, e.g. caused by opening the car door,
the device switches back on and automatically attempts to
connect to known mobile phones for about 2 minutes. If
there is no known mobile phone in range, the device switch-
es back to auto power function. The auto power function
also works if you have switched the device off manually.
NOTE
► If you deactivate the Bluetooth
mobile phone, the hands-free set switches to the auto
power function after around 2 minutes.
► Depending on the mobile phone used, it is possible,
however, that the automatic connection cannot be
made. If this happens, press the
restore the connection. You will hear a beep.
► With some mobile phones, the connection must also
be confirmed on the mobile phone itself. Please also
refer to the operating instructions for the respective
mobile phone.
► You can only switch on the auto power function if the
hands-free set is not in pairing mode.
► If you do not always have your phone with you during
your journey we recommend switching off the auto
power function. In this way you will prevent the hands-
free set from switching itself on and off due to vehicle
movements, and prevent the battery from discharging.
♦ Press and hold the
to turn on the auto power function. The operating/
charging LED
♦ Press and hold the
seconds to turn off the auto power function. The operat-
ing/charging LED
SBTF 10 D4
button
lights up orange briefly.
button
flashes orange three times.
®
function on your
button briefly to
for about 2 seconds
again for about 2
GB │ MT │
65 ■