Automatic Search - CityCom 202 10001 Bedienungsanleitung

6. Searching for services on your selected Satellite
Once you have moved the motor into position, you can search for the channels transmitted from
the relevant satellite. To search for services on your new selected satellite, Do as follows ;
5. When you have entered all these details in, press the
6. When the search has finished, press the
7. Repeat the process for all the transponders you want from this satellite.

7. Automatic Search

It is possible to use automatic search using the DiSEqC 1.2 motorised system.
1. Ensure that the positions for the satellite you want to search is correct. (see Section 3 and 4
above)
2. In the Main Menu, select the option channel searching and press the
3. In the Service Searching menu, select the Antenna Alternative that you have set for this
satellite.
4. When you search new services, please refer to Automatic Search of page 28.
5. When the search has finished, press the
Now that you have stored all the positions of the satellites and searched for all the services you
want, you can now use your receiver as normal. When you change to a service that is being
transmitted from a different satellite, you will have to wait a few seconds to allow the motor to move
into position to receive the new service.
1. Move the motor to the position of the satellite you wish to
search. (see section 5 above)
2. Select the service searching from the Main Menu and press
the button. To display the Service Searching menu.
3. Select the manual search option and press the
display the Manual Search menu.
4. Now enter the Frequency and Symbol Rate using the (0~9)
buttons. Next enter the Polarisation and FEC values using
the buttons.
button to view.
button to store and view the services.
button and the search will begin.
button.
button to
E34