CityCom 202 10001 Bedienungsanleitung Seite 73

3. Initial Satellite Position Search
This is required when you first set your receiver up to use DiSEqC 1.2 and sets the positions of all
pre-programmed satellites.
5. Highlight the DiSEqC Command Mode option and use the
Installer and press the
6. Highlight the Motor Control option and use the
press the button.
7. You will now see a warning message, press the
pre-programmed satellites should now be correct. If you have any other make or model of
DiSEqC 1.2 motor then you may need to store the satellite positions in yourself (Please refer to
the user manual for your motor).
8. Highlight the DiSEqC Command Mode option and use the buttons to change the value to User
and press the button.
9. You should now be ready to start storing services for the various satellites (see 5 onwards).
4. Manual Satellite Search
The purpose of this is to set the motor position for each satellite manually.
This is useful if the satellite you require is not available from the pre-programmed list (see 3 above).
To do this, you must access the Satellite Settings menu. Do as follows ;
1. Select Service Searching from the main menu and press the
Searching menu.
2. Select the Manual Search option and press the
Select the relevant Antenna Alternative that you are using for this satellite.
3. Enter the Frequency, Polarisation, Symbol Rate and FEC of a transponder on the satellite you
wish to find. This transponder information should be unique to this satellite.
4. Select the Antenna Alternative option and press the
menu.
5. Highlight the option DiSEqC Command Mode and using the
6. Highlight the option Satellite name and use the
find, use others if the name of the satellite you want does not appear.
7. When you have selected the satellite you wish to find, go down to the Movement option and again
using the buttons to start the motor moving.
1. Make sure your motor is installed correctly with the calibrations
adjusted for the region you are situated.
(Please consult the user manual for your motor.)
2. Make sure your receiver is set up to use DiSEqC 1.2.
(see section 2 above).
3. On the Main Menu, select Service Searching option and press
the button, you should now see the Service Searching
menu.
4. Highlight the option Antenna Alternative and press the
button to display the Satellite Setting menu.
button.
button, to display the Manual Search menu.
buttons to change the value to
buttons to change the value to reset and
button to continue. All motor positions of the
button, to display the Service
button, to display the Satellite Settings
buttons change this to Installer.
buttons to select the satellite you want to
E32