Teka IT 6450 IKNOB Montageanleitung Und Empfehlungen Zur Verendung Und Wartung Seite 23

fig.2
If you do not take any action in the
next 10 seconds the touch control will
switch off automatically.
When the touch control is activated,
you can disconnect it at any time by
touching the touch button
if it has been locked ("Lock" function
activated). The touch button
always has priority to disconnect the
touch control.
You can remove the knob
(2) from its housing at any
time. Through this action you
are blocking the rest of sensors.
This action is useful as safety
measure for avoiding non-desired
manipulations by children. The
light indicator (13) placed at the
housing's bottom will start blinking.
When the knob is placed again
in its position, the sensors will
be available again and the light
indicator will stop blinking.
Inside the knob's housing, an
only-off sensor is available (12) that
will allow you to switch off the hob
when the knob is out of its position.
PLATES ACTIVATION
Once the Touch Control is activated
through the sensor
can be switched on by following
these steps:
1 You have to choose the desired
zone for cooking by means of
pressing the zone selection sensor
(3). Zone selected is indicated by
the corresponding dot blinking of
the zone indicator (3). Twisting the
knob rightwards or leftwards, the
power level can be set between
0 and 9. The power value will be
shown on the corresponding power
indicator (4).
(1), even
2 By means of knob twist (2) a new
(1)
cooking level between 0 and 9 can
be chosen.
As long as the plate is selected, its
power level can be modified.
TURNING OFF ONE PLATE
If a zone is already selected, twist
the knob (2) leftwards until level 0 is
reached. The hotplate will switch off.
If switching off a zone, an H appears
on its power indicator (4), it means
the glass surface has reached high
temperature, there is risk of burns.
When the temperature decreases,
the power indicator (4) switches off.
TURNING ALL PLATES OFF
All plates can be simultaneously
disconnected by using the general on/
off sensor
(4) will turn off. If the heating zone
turned off is hot, its power indicator
(4) shows an H.
(1), any plate
When the hob is off, the
on/off general sensor
remain illuminated around one
minute. After that it will be switched
off. If the knob is removed from
its housing before that minute,
the indicator (13) placed at the
housing's bottom will start blinking,
if it's placed again in its position
before that minute ends, the on/
off general sensor
illuminated again.
Induction cooking zones have a built-in
pan detector. This way, the plate will
stop working if there is no pan present
or if the pan is not suitable.
The power indicator (4) will show a
symbol to designate "there is no pan"
if, while the zone is on, no pan is
detected or the pan is not suitable
If a pan is taken off the zone while it
is running, the plate will automatically
stop supplying energy and it will
show the symbol for "there is no pan".
When a pan is once again placed
on the cooking zone, energy supply
will resume at the same power level
previously selected.
The time for pan detection is 3 minutes.
EN
(1). All plate indicators
(1) will
(1) will be
Pan detector
23