Getting Ready - Sony VGP-MR100 Kurzanleitung

Getting ready

The steps necessary to prepare the unit for use differ, depending on whether a wireless LAN or a
network cable is used to connect to the computer.
1. Prepare the remote control for use
The remote control is necessary for operating of the Network Media Receiver.
2. Connect the Network Media Receiver to a TV
Select a suitable connector and cable according to the requirements of the TV monitor. It is also
possible to make the connection to the TV via a VCR.
3. Connect the Network Media Receiver to computer via a network cable c Page 16
Connect the Network Media Receiver to the computer using a network cable. When using a
wireless connection, this step is not required.
4. Connect power
Connect the supplied AC adapter to the Network Media Receiver to supply power.
5. Configure wireless LAN settings
When the Network Media Receiver is to be connected to the computer via a wireless
connection, without using a network cable, several wireless LAN settings must be configured.
When using a network cable connection, this step is not required.
6. Change the settings of the Network Media Receiver to match the c Page 28
network connection
Depending on the network environment, some settings of the Network Media Receiver may
have to be changed, setting whether to obtain an IP address automatically or use a fixed address.
The default setting is "Obtain an IP address automatically (using router)".
7. Configure settings at the computer
The computer must be configured to share its photos, video, and music.
When using a VAIO computer, the VAIO Media software must be configured.
When using a different kind of computer, corresponding settings must be configured.
VGP-MR100QSG(GB)_2-580-488-11(1)
c Page 10
c Page 13
c Page 24
c Page 25
c Page 30
9