Sony VGP-MR100 Kurzanleitung Seite 20

To connect the Network Media Receiver to a network
Connect the Network Media Receiver and the computer using the supplied network cable, as shown
below.
Case 1: Connecting via a router with built-in hub (system environment C, D, G)
Network cable
(not supplied)
To NETWORK
connector
Computer 1
To NETWORK
connector
1 Depending on the respective system connection environment, the connection may be different. For
details, contact the technical support department of your Internet provider.
2
Use a router with built-in hub that supports 100BASE-TX. All the networked equipment must support
100BASE-TX for optimum playback experience.
Notes
• When a router with built-in hub is used in environment G, set the IP address of the computer to a fixed
value, as described in "Assigning a fixed IP address to the computer" (page 22).
• The default setting of the Network Media Receiver is "Obtain an IP address automatically (using
router)". Depending on your system environment, this setting may have to be changed. For information
on how to do this, see page 28.
20
When a router with built-in hub is used in environment
nothing is connected to the WAN port.
ADSL modem, cable modem, or
similar without router capability
(third-party)
Router with built-in hub
(third-party)
Network cable
(supplied)
Network cable
(not supplied)
Computer 2
VGP-MR100QSG(GB)_2-580-488-11(1)
G
,
1
2
To NETWORK
connector
Network Media Receiver