Inserting The Batteries; Using The Remote Control - Sony VGP-MR100 Kurzanleitung

1 Prepare the remote control for use

Inserting the batteries

As shown in the illustration, open the battery cover lid of the remote control, and insert two size
AA (R6) batteries (supplied).

Using the remote control

To use the remote control, point it towards the remote control sensor on the Network Media
Receiver, and press the appropriate buttons.
Remote control sensor
z
Hints
• If the operating range of the remote control decreases, replace both batteries with fresh ones.
• After replacing the batteries, the TV manufacturer code (pages 11, 12) must be set again.
10
Verify e/E polarity, and
insert the batteries from
the E side.
VGP-MR100QSG(GB)_2-580-488-11(1)