Timer Function - Silvercrest SBB 850 B2 Bedienungsanleitung

Programme 12: Bake
For the additional baking of breads that are not
brown enough, not baked through or for ready-
made doughs. There are no kneading and rising
processes in this programme. The bread is kept
warm for up to one hour after the baking process.
This prevents the bread from becoming too moist.
Programme 12 bakes the bread for 60 minutes.
To stop these functions early, press the Start/Stop
button until your hear a long signal tone. To
switch the appliance off, remove the plug from the
wall power socket.
NOTE
► In programmes 1, 2, 3, 4, 5, 6, 8 and 9, a
signal tone sounds during the sequence and
"ADD" appears on the display. Directly
after this, add the other ingredients, such as
fruit or nuts. You do not need to interrupt the
programme.
The kneading blades
ingredients. If you have set the timer, you can
put all the ingredients into the baking mould
at the programme start. In this case, however,
fruits and nuts should be chopped beforehand.

Timer function

The timer function allows you to delay the baking
process by a preset time.
Use the arrow buttons
desired completion time for the baking process.
The maximum time delay is 15 hours.
WARNING! RISK OF FIRE!
► Before you bake a particular type of bread
with time delay, try out the recipe first to
ensure that the proportions of the ingredients
are correct, that the dough is not too firm or
too thin, and that the quantities are not too
much and could possibly overflow.
1) Select a programme. The display
the required baking time.
■ 76 │ GB │ MT
will not chop the
and to set the
indicates
2) Using the arrow key
the end of the programme. The first activation
pushes the completion time back to the next full
interval of 10 minutes. Each subsequent press
of the arrow key
time by 10 minutes. You can accelerate this
procedure by holding the button pressed
down. The display
period of the baking time and delay time.
If you exceed of the maximum time delay, you
can correct the time with the arrow key
3) Confirm the programming of the timer with the
Start/Stop button
The operating light
on the display
time starts to run.
As soon as the programme starts, the operating
light is on permanently. When the baking pro-
cess has been completed, you will hear ten beeps
and the display indicates 0:00.
Example:
It is 8:00 a.m. and you would like to have fresh
bread in 7 hours and 30 minutes, in other words
at 3:30 p.m. Start by selecting programme 1 and
then press the arrow keys
in the display , as the time until completion is
7 hours and 30 minutes.
NOTE
► The timer function cannot be activated with
the programme "Jam".
NOTE
► Please do not use perishable ingredients such
as milk, eggs, cream or cheese, etc. when
using the time delay function.
, you can delay
delays the completion
shows you the whole
.
starts to flash. The colon
flashes and the programmed
until 7:30 appears
SBB 850 B2
.