Starting A Programme - Silvercrest SBB 850 B2 Bedienungsanleitung

Starting a programme

Start the programme with the Start/Stop button
NOTE
► Programmes 1, 2, 3, 4, 6 and 8 start with a
10 to 30 minute preheating phase (except
Super Rapid, see table for programme sequenc-
es). The kneading blades
This is not a malfunction of the appliance.
The programme will carry out the various operations
automatically.
NOTE
► For the programmes 1, 2, 3, 4, 5, 8, 9 and
10, you will hear a beep after the "Rise 2"
programme section and "RMV"
on the display
kneading blades
Open the appliance lid
little to one side and pull the kneading blades
from the two drive shafts in the baking mould
Close the appliance lid
If you do not want to remove the kneading
blades , simply wait. The appliance will
automatically resume the programme.
You can monitor the programme sequence through
the viewing window
Occasionally, condensation may build up on the
viewing window during baking. The appliance
lid may be opened during the kneading phase.
NOTE
► Do not open the appliance lid
rising or baking phases. The bread could
collapse.
■ 78 │ GB │ MT
do not move.
appears
. You can now remove the
from the dough:
, push the dough a
.
of your bread maker.
during the
Ending a programme
. When the baking process has been completed,
you will hear ten beeps and the display
0:00. At the end of the programme, the appliance
automatically changes to a keep-warm mode for
up to 60 minutes.
NOTE
► This does not apply to programmes 6, 7 and 11.
In this mode, warm air circulates inside the appli-
ance. The keep-warm function can be ended early
by keeping the Start/Stop button
a beep is heard.
DANGER! ELECTRIC SHOCK!
► Set the ON/OFF switch (--/O)
position before you close the appliance lid
The appliance should always be disconnected
from the power grid when not in use! Unplug
the appliance from the power outlet.
.
indicates
pressed until
to the "O"
.
SBB 850 B2