Dometic Midi Heki E Montage- Und Bedienungsanleitung Seite 15

Midi Heki roof light
fig. 9
See
➤ Place the 11 mounting supports on the inside of the vehicle all the way into the
recess of the outer frame.
If you use wooden rails as reinforcement
A
NOTICE!
Do not drill through the roof construction.
➤ Pre-drill two 2.2 mm holes for each mounting support in the roof construction
(A).
➤ Fix the mounting supports on the roof with the ∅ 3.5 mm (B) screws included.
For other constructions, suitable screws must be used (not in scope of delivery).
➤ Fix the 11 mounting supports with the ∅ 4 mm fixing screws.
To do this use the large holes in the mounting supports.
➤ Tighten the screws 10 minutes after installation.
fig. 0
See
A
NOTICE!
Electric version: Make sure that the power supply line from the vehicle
is inserted in the inner frame opening and does not get stuck.
➤ Press the inner frame into the groove (1) on the mounting supports.
fig. a
See
You can also fasten the inner frame on the two short sides using suitable screws (not
in scope of delivery):
➤ Drill the two fastening holes beforehand.
➤ Screw the screws into the fastening holes.
EN
Installing the Midi Heki
9