Dometic Midi Heki E Montage- Und Bedienungsanleitung Seite 14

Installing the Midi Heki
Only electric version:
!
WARNING! Beware of injury
Disconnect the vehicle power supply before you begin and make sure it
cannot be restarted.
A
NOTICE!
Make sure that you do not damage any cables during installation.
➤ Lay the power supply line in the middle on the long side, where the hinges
should go.
fig. 5
See
➤ Check that the roof light has sufficient space around it (approx.1 to 2 mm) in the
wall section.
fig. 6
See
➤ Clean the roof opening in the mounting area.
fig. 7
See
A
NOTICE!
Observe the sealant manufacturer's instructions.
➤ Seal the mounting frame with a flexible non-hardening sealing compound (e.g.
SikaLastomer-710).
fig. 8
See
➤ Check the direction of travel when installing.
You can fit the roof light sideways (hinge-side at front in direction of travel) or
lengthways (hinge-side on left or right in direction of travel).
➤ Place the outer frame in the middle of the roof opening.
I
NOTE
Electric version: Pay attention to the power supply lines.
➤ Press the outer frame in the roof slightly so that the packing compound spreads
out.
8
Midi Heki roof light
EN