Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WET CLEANING
The vacuum cleaner may aspire water during wet vacuum cleaning. However, avoid aspiration
of solids; the wet vacuum cleaning mode is for removal of water, e.g. from spills or after
washing of floors, etc.
1. Make sure that the device is disconnected from mains.
2. Disengage the clamps (B5) and lift an engine's set using a handle.
3. Check if the container, tubes and a hose are dry and without any dirt.
4. Take water filter tube off (B4), because its presence during wet cleaning may lead to froth
production. Do not pour water into the water tank (B1).
5. Put the water filter tank on and put an engine's set back on the device and lock the clamps.
6. Connect a sucking hose (C1), using a connecting element (C4) of sucking inlet of the vacuum
cleaner (B6). For wet cleaning, use a brush (D4) after first removing the bristles. Connect the
brush to the telescopic suction tube (C5) or directly to the handle (C2).
7. Connect the device to the mains and use a switch (A1) to switch a vacuum cleaner on.
8. If foam starts flowing from the container (B1) switch off the device immediately and empty
the container from dirty water. To reduce the foaming add to the container (B1) a few drops
of antifoam.
9. When wet vacuuming, ensure that the unit does not suck more than 5 liters of water. This
volume corresponds to the lower edge of the water filter body (B2).
WARNING: DO NOT SUCK MORE THAN 5L OF WATER. EXCESSIVE WATER CAN LEAD TO EQUIPMENT FAILURE.
10. Turn off the vacuum cleaner, disconnect it from the mains and clean it.
The device has an air blow function. You can use this function in order to dry objects or to
clean stuck washbasin or bath. Connect a sucking hose to cover of HEPA filter case (A4) (draw-
ing 12) and next switch the device on. You can use a round brush for cleaning if you remove a
part with bristle before.
CLEANING AND MAINTENANCE
Before each cleaning, make sure that the device is disconnected from mains.
After use, empty, clean and dry a container. Dump and dirt may be a cause of unpleasant scent.
Before removing dirt and contaminated liquid disconnect the sucking hose (drawing 13),
disengage the clamps and lift the engine's set.
Foam filter can be washed in warm water with some soap or in running water. It should be
dried properly before it is put on float chamber again.
ATTENTION! Foam filter must not be cleaned in hot water or washed in a washing machine.
Check if a valve in float chamber can be moved easily. If necessary, clean it (drawing 14). In
order to check if the float works properly lift the engine's set and shake it.
Check cleanliness of HEPA filter regularly. If a filter is dirty, it must be cleaned. After a longer
period of use HEPA filter will lose its properties.
Change it to a new one then.
19
Werbung
Inhaltsverzeichnis
