Auping Kiruna Sami Gebrauchsanweisung Seite 23

The box spring fails to
respond to the infrared
remote control
Infrared remote
control, lights blinking
Hinge defect
_03JMR_4470 - BW.pdf - pag.21
Cause
The signal from the
handset is not being
picked up by the
receiver in the control
unit. The signal may fail
to reach the receiver if
the handset is a
substantial distance
from the control unit or
the latter is covered by
a duvet, for example.
Processor failure.
Transport failure.
LET OP !!! Lage resolutie!
Search
Check if the system
works by pointing the
handset directly at the
control unit beneath the
bed. Check if the control
unit has been fixed
properly.
Solution
Remove the duvet or
blankets that may be
interrupting the signal.
Install IR preamplifier if
necessary.
Reset. Take batteries
out, push some buttons.
Put batteries in again.
Replace box spring.
November 10, 2009
GB21