Before Use; Charging; Oiling The Blades - Silvercrest SHBS 700 A1 Bedienungs- Und Sicherheitshinweise

Before use

Note: The product may be powered using the
built-in rechargeable battery or the plug-in mains
adapter .
7
Remove all parts from the package.

Charging

Note: Before first use, the rechargeable battery
in the product should be charged for at least
90 minutes. A charging time of 90 minutes is also
required subsequently.
The product can be charged directly or indirectly
by using the charging base
Note: The charging process is shown on the display
of the charging display
display .
10
Direct charging (see Fig. C)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (Press the ON / OFF button
or twice, until the ON / OFF indicator light
goes off).
Insert the cable plug of the plug-in mains ad-
apter into the socket on the underside of
7
the product.
Insert the plug-in mains adapter
socket which meets the product requirements.
Indirect charging (see Fig. D)
To avoid injuries and damage to the product,
always switch the product off before charging
the battery (Press the ON / OFF button
or twice, until the ON / OFF indicator light
goes off).
Connect the cable plug of the plug-in mains
adapter with the charging base
7
Place the product into the recess of the char-
ging base with the cutting unit
6
upwards.
Insert the plug-in mains adapter
socket which meets the product requirements.
.
6
and the battery-status
9 b
once
3 b
into a
7
once
3 b
.
6
pointing
1
into a
7
Note: During the charging process, the red
charging display
status display
10
Note: As soon as the battery is charged, the
battery status display
charging display
Note: You can use the product for up to approx.
60 minutes with a full battery without it being
connected to the power supply.
Note: When the battery is almost empty, the char-
ging display
9 b
product may only be used for a short period of time
without being connected to the power supply.
Operating using the plug-in mains
adapter :
7
If the product stops working during use due to an
empty or insufficient battery, you can continue if
the plug-in mains adapter
Insert the cable plug of the plug-in mains ad-
apter into the socket on the underside of
7
the product.
To avoid injuries and damage to the product,
always switch the product off before connecting
to the plug-in mains adapter
Insert the plug-in mains adapter
3 a
socket which meets the product requirements.
After a few seconds you can switch on the pro-
duct by pressing the ON / OFF buton
or twice for the desired speed. If the product
does not start working immediately, switch it
off by pressing the ON / OFF button
or twice until the indicator light
Wait approx. 1 minute before you try to switch
it on again.

Oiling the blades

3 a
It is recommended that you oil the blades before
first use and after cleaning to guarantee complete
functionality (see Fig. E).
Apply one or two drops of blade oil
ween the blades and distribute them evenly.
Wipe away any excess oil using a cloth.
will light up and the battery
9 b
will show the battery level.
will switch off, while the
10
will continue to be red.
9 b
on the display will flash. Then, the
is connected.
7
.
7
7
goes off.
3 a
into a
once
3 b
once
3 b
bet-
14
GB 11