Oil Change; Air Filter - Texas Vario 50 TR/W Bedienungsanleitung

Speed can be adjusted while driving. Activate the left handle on the dashboard and set in
one of the 4 different speeds
Stop the engine
Release the stop lever to turn off and stopping the engine
Note that the blades will still rotate up to 5 seconds after releasing the lever.

Oil change

The oil must be changed after the first 5 hours of use. After that the oil must be changed at
least once a year.
1. Let the engine run for 5 minutes to warm up the oil. This makes it run easier and
make the oil change more complete.
2. Turn off the engine after 5 minutes. Take off the spark plug cap. Unscrew the cork
for the drain plug. Theo oil now runs out of the engine. Keep a suitable container
ready to collect the oil.
Note: The engine may only be tilted backward at an angle of max 45 degrees. Refit
the drain plug and pour fresh oil into the engine.
3. This is done by removing the oil stick and filling with correct amount of oil.
4. Mount the spark plug cap.
Alternatively use an oil changing kit:
1. Suck the oil up through the oil filler hole using the syringe. Use the hose as an
extension piece to reach the bottom of the engine. Transfer the used oil to the
accompanying container.
2. Fill the engine with new oil, type SAE30. (0.6 Litre)
Check the oil level using the dipstick on the oil bung
Remember to dispose of the used oil so that it is not harmful to nature.
Use your local recycling station. Oil and oil changing kit is not included.

Air filter

The air filter must be checked and cleaned regularly. If the filter has not been cleaned for
some time, the power of the engine is reduced, and the engine may be damaged.
Vario 50TR /WB
B&S engine: Follow the instructions in the separate engine manual.
Vario 50TR/W. See fig 8
1. Clean around the air filter before it is removed.
2. Press down the two flaps and carefully pull of the cover.
3. Carefully remove the paper filter and check it. Brush it with a soft brush. If it is very
dirty, it must be changed. Take care that no dirt gets into the intake of the engine.
4. Check that all parts are fitted correctly and the cover closed as shown in the picture
20