Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning
The machine should be cleaned after use. Use a garden
hose to wash off soil and dirt. The chassis number should
only be cleaned with a damp cloth to avoid unnecessary
wear. Avoid using a high-pressure washer during cleaning.
Changing the oil
The oil should initially be changed after the first 5 hours of
use, and thereafter once per year. Use an oil extractor kit.
1.
Suck the oil up through the oil filler hole using the
syringe. Use the hose to reach the sump.
2.
Transfer the used oil to the container.
3.
Fill the engine with new SAE-30 oil.
4.
Check the oil level using the dipstick.
Remember to dispose of used oil in a safe way.
Oil and oil extractor kit are not included
Storage
•
If the machine is likely to be stored unused for prolonged
periods, follow the instructions below. This will ensure
longer machine lifetime.
•
Wipe the surfaces down with an oily cloth to prevent
rust.
•
Always store the machine in a dry, clean location.
Extra brushes
Extra brushes can be purchased:
Set of 9 pcs. nylon/steel brushes: Art. no. 90061102
Set of 9 pcs. steel brushes:
Buy them from your dealer.
Troubleshooting
The motor will not start
1.
Check the spark plug.
2.
Check there is fresh gas in the tank.
3.
See separate motor instructions for further
troubleshooting.
The motor is not running smoothly
1.
Check there is fresh gas in the tank.
The trimmer will not rotate
1.
Check the cables are in good working order and fitted
correctly.
2.
Check and remove wedged grass.
Noise, vibration and precautionary measures
1.
Long-term exposure to noise levels exceeding 85 dB (A)
are damaging. Always use ear defenders when the
machine is being used.
2.
To reduce noise levels further, only use the machine in
an open environment.
3.
Vibrations can be reduced further by holding the handle
firmly.
4.
To avoid disturbing others, the machine should only be
used during the daytime.
5.
Always wear close-fitting work clothes, hard-wearing
work gloves, ear defenders and non-slip boots with steel
toecaps.
6.
Take a 30-minute break every 2 working hours.
Art. no. 90061103
Specification
Engine
Effect
Working width
Brushes
Transmission
Wheels
LpA
LwA
Vibrations (L / R)
Weight
12
TG595 173cc (Rato RV170)
2.9 KW/3000 Rpm.
Max 70 cm
9 pcs.
Push
14"
84.2 dB(A)
104 dB(A)
2
2
6,7 m/s
/ 5,0 m/s
33 Kgs
Werbung
Inhaltsverzeichnis
