Oil Change; Air Filter; Spark Plug; Storage And Maintenance - Texas Rider 6100E Bedienungsanleitung

Oil change

Oil should be changed for the first time after 2 hours,
then at least 1 time per year.
You will need an oil extractor kit. Art. no. 40-11336
Oil and oil extractor kit is not included
Use an extractor kit and do as follows:
1. Turn on the engine and let it run for 5 min or until
the engine is hot. A hot engine liquefies the oil
which makes it easier to drain.
2. Suck the oil up through the oil filler hole using the
syringe that came with the oil extractor kit. Use the
hose to reach the sump.
3. Transfer the used oil into a empty container.
4. Fill the engine with SAE-30 oil.
5. Check the oil level using the dipstick. (Min / Max)
Remember to dispose the used oil so that it does
no harm to nature. Use your local recycling station.

Air Filter

The air filter should be inspected and cleaned regularly.
If the filter has not been cleaned for a long time, the
engine's power will drop.
1. Clean around the air filter before removing the cap.
2. Push the two flaps down and gently pull the cover
3. Carefully remove the paper filter and inspect it.
Brush it with a soft brush. If it is very dirty, replace
it. Be careful that no dirt gets into the inlet.
4. Wash the black foam element in the right side in
warm water and soap.
5. Press the water out of the foam element and let it
dry. Put a few drops of SAE-30 oil on the filter to
moisten it lightly. Carefully squeeze any surplus oil
out of the foam element and reattach.
6. Please note that all parts are assembled correctly
and properly closed, as shown in the picture.

Spark plug

1. Remove the spark plug.
2. Brush off dirt from the spark plug.
3. Use a spark plug wrench to loosen the spark
plug.
4. Check the insulation is intact.
5. Clean the spark plug with a wire brush.
6. Measure the electrode, taking care not to
damage the electrode.
7. The distance should be: 0.7 to 0.8 mm
8. If the spark plug is undamaged refit or replace.
9. Reattach the spark plug.

Storage and maintenance

Maintain your rider: Check all bolts, screws, nuts and
deck. Dismount the blade and the belt plastic cover for
regular cleaning. Always make sure that the blade is
sharp. It's a good idea to take your lawn rider to an
annual service check with your authorized service
dealer. See your nearest service center at
www.texas.dk.
Storage: After use the rider kept in a dry and clean
room. Clean the machine after every use. Grass and
dirt must be removed from the underside of the deck.
By tipping the rider (for cleaning) is recommended to tilt
the front up (max. 45 degrees). If you tilt it sideways,
the carburetor and air filter always face upwards, since
oil may run out and destroy the engine. Be aware that
removing the spark plug before the rider maintenance.
Winter storage: Empty the fuel tank and let the engine
run until the gasoline in the carburetor is used up. Spark
plug removed. Remove the spark plug and add a
teaspoon of oil (engine oil) in the hole. Pull the starter to
distribute oil. Mount the spark plug, but not the spark
plug cap. Change oil as described in the section above.
Spray silicone lubrication into the cables and move
them.
Finally, clean the rider thoroughly. Dip a cloth in oil and
luricate metal parts to prevent rust.
Towbar
The machine is fitted with a towbar.
Only a small trailer may be mounted after the rider. (no
other retrofitted accessories).
The maximum load on the trailer is 25 kg, which means
less cargo such as grass, branches and leaves.
If the towbar is used for larger loads or other
accessories than the carriage, the warranty does not
cover.
20