Husqvarna 2011 WR 250 Merkmale, Gebrauch, Wartung Seite 86

REAR BRAKE PEDAL POSITION ADJUSTMENT
The position of the rear foot brake pedal as to the footrest may
be adjusted according to the individual needs. For the adjusting
proceed as follows:
- loosen the screw (1);
- turn the cam (2) in order to adjust the brake pedal idle stroke
(A);
- the operation done, tighten the screw (1).
The adjusting operation carried out, adjust the idle stroke of the
pedal as follows..
REAR BRAKE IDLE STROKE ADJUSTMENT
The rear brake foot pedal should have a (B) 5 mm (0.2 in.) idle
stroke before starting the true braking action.
Should this not happen, operate as follows:
- loosen nut (3);
-
operate the pump rod (4) to increase or decrease the idle stroke;
- tighten nut (3) at the end of the operation.
WARNING
When the idle stroke figures are not met, the
brake pads will be subjected to a fast wear
that may bring to the TOTAL BRAKE INEFFEC-
TIVENESS.
CHECKING THE FLUID LEVEL
The level (A) must be set between the pump tank notches.
EN - 27