Husqvarna 2011 WR 250 Merkmale, Gebrauch, Wartung Seite 111

REAR TAIL LIGHT BULB REPLACEMENT
- Back light with 12V-21W stop light, 12V-5W parking light;
- Turn signals bulb of 12V-10W;
Remove the two fastening screws (1) in the inner side of the rear
fender and the lens (2).
EN - 52
Pull the lamp (3) inside, turn it counterclockwise then remove it
from the lamp holder.
After replacement, reverse operations for reassembly.
NOTES: make sure not to tighten the screws
excessively.
REPLACING THE NUMBER PLATE LAMP
Pull out the number plate lampholder (4) from the back of the
vehicle. Pull out the lampholder and the bulb. Rotate the bulb
(5) to remove from the lampholder.
Once the bulb has been replaced, reverse the above procedure.
4
5