Husqvarna 2011 WR 250 Merkmale, Gebrauch, Wartung Seite 103

FLUID CHANGE
The brake fluid should be checked and changed in accordance
with the Periodic Maintenance Chart or whenever it is contami-
nated with dirt or water. Don't change the fluid in the rain or
when a strong wind is blowing.
1A
EN - 44
CAUTION!
* Use only brake fluid from a sealed con-
tainer (DOT 4). Never use old brake fluid.
* Never allow contaminants (dirt, water,
etc.) to enter the brake fluid reservoir.
* Don't leave the reservoir cap off any
length of time to avoid moisture contami-
nation of the fluid.
* Handle brake fluid with care because it can
damage paint.
* Don't mix two types of fluid for use in the
brake. This lowers the brake fluid boil-
ing point and could cause the brake to be
ineffective. It may also cause the rubber
brake part to deteriorate.
1
To replace the fluid, proceed as follows:
- Remove the rubber cap on the bleeding valve (1) or (1A).
- Attach a clear plastic hose to the bleeding valve on the brake
caliper and turn the other end of the hose into a container.
- Remove fluid reservoir cap (2) or (2A) and the rubber.
- Loosen bleeding valve on the brake caliper.
2A